Bosch wfe 2021 инструкция на русском языке

SOURCE: fault code 01

this is actually a fault code error code 1 not one minute check your manual as codes different on some machines from memory i think 1 is a filling fault this machine uses fuzzy logic if water fill takes longer than 4 mins (low pressure) machine stops can be restarted by pressing start button.
see if machine will complete just a rinse cycle.

good luck

Posted on Jan 18, 2008

SOURCE: Bosch WFE 2021 machine does not complete wash…

Hello i have just had the same problem, i followed the manufacturers instructions (drained and cleaned pump etc) but the washer would not empty and fault 3 spining and rinsing would show. i tried to run the pump on cycle 7 with the filter cover open and the pump was not running. At the rear of the pump there is a spring/retainer this had dislodged and would not allow the pump to run it took a light push (with the power off) to relocate this spring/clip in its housing. Hope this helps

Posted on Feb 05, 2009

SOURCE: i have a bosch WFE 2021, the fabic softner will

Remove the drawer from the dispenser housing, get a stiff piece of wire, and form a right angled bend in it about 1″ long.
Poke the wire into the holes in the top of the dispenser and wiggle it about to clear the holes.
This should solve the problem.
Please rate my solution.
Thanks.

Posted on Dec 21, 2009

SOURCE: Hello! How can I get the instructions manual for

You’re in luck —
http://www.bosch-home.co.uk/
click on «download product manuals»
click on «click here to download product manuals» — this will open a new tab or window.
Enter WFE2021EE/01 and click on Go.
results are in spanish, but I expect you’ll be ok with that.

Posted on Jan 11, 2010

×

Capacity WFE2021 Bosch washing machine

Hello! How can I get the instructions manual for

You’re in luck —
http://www.bosch-home.co.uk/
click on «download product manuals»
click on «click here to download product manuals» — this will open a new tab or window.
Enter WFE2021EE/01 and click on Go.
results are in spanish, but I expect you’ll be ok with that.

Bosch WFE 2021

I suggest that you check the brushes in the motor for wear.
Remove rear panel, remove drive belt, undo bolts securing motor, unplug motor lead and earth wire.
Lever motor back, keeping hold of it, and remove.
Check the brushes, they are at the opp end to the motor pulley, if there is less than 8mm left, then replace brushes.
I would also check the pump filter, and clean if req’d.
Please rate my fixya solution.
Thanks.

Flickering display panel Boschwfe 2021

It may be the door interlock that is faulty. This is the cheaper solution however it maybe the the electonic board. In any case it needs the attention of a bosch Technician. Cross your fingers its the door interlock.
0417362396 Melbourne metro Area
Regards Sam

Bosch WFE 2021 machine does not complete wash…

Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.

Fault code 01

Схема с размерами
JPG, 11.1 Кб

Схема встраивания
JPG, 18.43 Кб